Home > Event Id > Windows 7 Disk Error Event Id 11

Windows 7 Disk Error Event Id 11

Contents

The backup lasts around 30 minutes, everything looks fine, the Exchange backup seems complete and ready to be restored if needed (that's nice).But once or twice a month, and recently once I have just switched the SATA cable to Port1 as all errors seem to happen on Port0. Hardware or software issue? x 307 Anonymous I got this error in my event viewer along with these: Event ID: 129 Source: HpCISSs2 Description: Reset to device, \Device\RaidPort0, was issued. More about the author

Unfortunately it came back about a month later, but same process repaired it again. Why not have an app where you can simply see each \device id that corresponds to each bloody disk!!!!!!  Disk 1 -> \device\harddisk#\DR# or something? In this case, the error is likely associated with a USB drive attached to the server. Artikel-ID: SLN167235 Senast ändrad: 07/14/2015 10:21 AM Betygsätt den här artikeln Korrekt Användbart Lätt att förstå Var den här artikeln till nytta? http://answers.microsoft.com/en-us/windows/forum/windows_7-hardware/event-id-11-disk-the-driver-detected-a-controller/fb0e7207-2bde-4fcd-b1b8-643a9f20196a

Event Id 11 The Driver Detected A Controller Error On Device Harddisk1 Dr1

How to deal with a coworker that writes software to give him job security instead of solving problems? Have done all the usual troubleshooting as you would expect. Join them; it only takes a minute: Sign up Here's how it works: Anybody can ask a question Anybody can answer The best answers are voted up and rise to the

  1. Thus it was concluded that controller was faulty, and I went shopping for a new motherboard.
  2. The driver detected a controller error on \Device\Harddisk3\DR3.
  3. When Windows loaded and this Event ID appeared, Windows took a long time to start up (even when the swap file was moved to the C: drive).
  4. Any advice?
  5. Once that is addressed, diagnostic utility for Hard-drive will help figure out what is going on with it.
  6. I am just worried about losing data.
  7. I tried today to install it (downloaded the CD Image from the download section here) but it seems ecoManager is not compatible with Win Server 2008 R2...
  8. Any clue?So I'm left with the regular Windows method of enabling/disabling the sleep mode (for the record it's here: Control Panel / Device Manager / Universal Serial Bus controllers / Generic
  9. Forum Event ID: 41 Kernel-Power Error Forum Need help with error event id 55, don't know where to look for the problem Forum Event ID 11 cdrom crashing vista?

They both have a qlogic 1040b scsi adapter, directly connected to digital ba356 scsi storage box. Did you know you can avoid “tarnishing” your license in such scenario by Skipping product key page during Windows 7 setup? need to really see the setup to make things easier. Event Id 11 Kerberos-key-distribution-center So the disk numbers shown in the Disk Management console (Disk 1, Disk 2, Disk 3, etc) correspond to the \Device\Harddisk# in those Event Log errors.

I updated the firmware and raid drivers and the problem was resolved. Event Id 11 Disk The Driver Detected A Controller Error How can I determine what hard drive / storage device is "\Device\Harddisk2\DR2"? Disabling the card reader through Device Manager seems to have stopped the intermittent error messages. There is no authoritative list of USB drives compatible with different versions of Windows Server; however, the Windows Small Business Server (SBS) team has compiled a list of USB drives and

When I plug a USB stick into the slot, diskpart shows the arrival of "Disk 6". Event Id 11 Wininit Under there you will have several nodes for "Harddisk0" ... Right-click the gray portion of the basic or dynamic disk whose disk number matches the "Harddisk#" in the error message. This is an OPTIONAL SCSI command that may or may not be supported by the device.

Event Id 11 Disk The Driver Detected A Controller Error

Run manufacturer hard disk diagnostics. https://community.spiceworks.com/topic/304581-driver-detected-a-controller-error-which-hdd-is-device-harddisk2-dr2 I checked and saw that it has Western-Digital Hard-drive, and went to their support site to download free utility. Event Id 11 The Driver Detected A Controller Error On Device Harddisk1 Dr1 x 129 Giles Collard I have had the above Event ID on my system logs which would show up as soon as the system had booted and at random times there Event Id 11 Windows 7 Disable sleep mode in power management? (this might not be very good for the drive to spin all the time).

Seculla Aug 09, 2012 @ 17:44:05 It's the stupid SATA cables. my review here Now that I feel it is fully resolved, I thought I’d share my conclusion (and the process) – hopefully it will help few others out there who are struggling with this. x 294 Anonymous I got this error when I mistakenly browsed my USB card reader without a card in it. Lucia Storbritannien Surinam Swaziland Sverige Sydafrika Tadzjikistan Taiwan Tanzania Tchad Thailand Tjeckien Togo Trinidad och Tobago Tunisien Turkiet Turkmenistan Turks- och Caicosöarna Tyskland Uganda Ukraina Ungern Uruguay USA Uzbekistan Vanuatu Venezuela Event Id 11 Atapi

I run ms cluster on two pc. x 233 Anonymous I've had three of these errors pop up on our Level Platforms alerts. Archives Archives Select Month October 2015 (1) August 2015 (1) March 2015 (1) November 2014 (1) March 2013 (1) December 2012 (1) September 2012 (1) May 2012 (1) March 2012 (1) click site Targetid1 > Logical Unit Id 0 look at identifier and type.

DigDeep Dec 28, 2012 @ 14:20:21 I had this problem too. Event Id 11 Custom Dynamic Link Libraries Feb 19, 2013 at 4:05 UTC Do you have any Management software installed for the RAID?  That would have it's own logging and hopefully diagnostics too. 0 Jalapeno Sorry for not following up on this...

I have HP RAID management software but it didn't really help either since I have so many other hard drives (USB, iSCSI) that are not on the internal RAID.

that should help. One 1040b's scsi id is 6, and the other is 7. I am watching it carefully and will replace it if it happens one more time. Event Id 11 Rpc At last I resolved it successfully.

My Windows Server Backup is scheduled at 9:00PM daily. After that I was able to write to cd, dvd, and able to delete rewritable cd. ( I left HD on the same port!, but hard disk can also cause this That's the first place I looked but I'm unsure how to correlate Harddisk2\DR2 to any of those drives. http://pdctoday.com/event-id/windows-xp-error-event-id-29.php I am pretty confident that this is the right diagnosis, as we went through a lot of trial and error investigative work, in a space of few weeks, after it started

How did they shoot the hostess scene? I have ( C: ) two SSD drives in RAID configuration, one ( D: ) internal HDD, and one ( F: ) external HDD. Inserte un disco en la unidad /device/Harddisk5/DRS, ALGUNO DE UDS SABRIA DARME UNA ORIENTACION A KE SE DEBE Y COMO RESOLVERLO,? x 275 Corey Monteiro Boot-up was also very slow when these errors began to occur.

But I don't think ignoring these errors is a good strategy.After reading some MS forum I tried this: Set service "Windows Driver Foundation User mode Driver Framework" to automatic (wudfsvc). Adi R May 13, 2012 @ 15:00:20 Since this post is still very popular, and because I went through 2 more hard-drive since then, here's what I want to add: Statistically, I ran full diagnostics on my two hard drives (a 250GB Deskstar SATA with 3 partitions that came with the system and a 120GB ATA Barracuda with 2 partitions that I WHY ENCODE IT IN THE FIRST PLACE????   I mean seriously google "what drive is \device\harddisk1\DR1" and you will get a bazillion responses just like this one with 400 responses -

Brad Adi R Jun 08, 2012 @ 03:03:53 Sorry to hear there are troubles. I think maybe this post can help explain how to map between the number and the Hard-disk (look at photos especially), but if you have only one (most common), then there Could this be an issue with the enclosures and not the drives maybe a problem with the port multiplier and that is why it is only 3 out of the four Boot-up returned to normal speed and errors went away after disconnecting the card reader.

Find each DeviceType:REG_SZ:DiskPeripheral entry under the Targetid#\Logicalunitid0.